General

• ultra low profile - only 18 mm
• high pressure duct fan to exhaust air and fumes through long lengths of rigid or flexible ducting
• hole diameter 6"/15cm - duct size 4"/10cm
• integral backdraught shutter
• adjustable timer - 3-15 minutes
• dynamic humidistat with night time set back and anti-hunting device
• humidistat model with neon to show fan in manual operation
• neon indicator on two-speed models to show fan in over-ride mode
• neon indicator on single speed models to show fan is switched on
• easy plasterboard ceiling nstallation with (optional) Ceiling Ring
• easy wiring of "T" and "H2R" models with quick fix terminal block
• whisper quiet operation
• IPX4 - Splashproof - can safely be installed in Zones I and II

Specification

• casings from shockproof and heat resistant plastics
• double insulated motors of shaded pole type mounted on self-lubricating, sealed ball bearings for long life
• motors incorporate thermal cut-out
• maximum ambient temperature - 40°C

Compliance

• EN60335-2-80
• EC Low Voltage Directive 73/23-93/68
• EC Directive EMC89/336
• CE marked

Range

• RMF100 - standard
• RMF100T - overrun timer
• RMF1002R - two speed model - continuous running at low speed, remote switch to high speed.
• RMF100H2R - humidistat and timer for automatic moisture extraction - choice of speed and operation via remote switch

SELV MODELS AVAILABLE

Features

fan profile

quick fit terminal block

Installation

wall

ceiling

Wiring

standard

T, 2R, H2R

Pressure

Dimensions

Data

Accessories

Fixed Grille

Gravity Grille

Wall Vent Kit

Wall Duct Kit

Ceiling Ring

Typical specification

Supply and install a Vectaire RMF1002R recessed duct fan for toilets, shower-rooms, bathrooms and utility rooms as supplied by Vectaire Ltd, Lincoln Road, Cressex Business Park, High Wycombe, Bucks, HP12 3RH. This fan is to be suitable for installation either in a ceiling or a wall with a 6”/15cm hole size and a 4”/10cm outlet. The fan should be complete with an integral backdraught shutter and have two speeds with remote switching. The fan must run continuously at low speed, and be capable of being boosted to its maximum speed by use of a remote switch. There should be a neon indicator to show when the fan is in over-ride mode. The fan should be made of shockproof and heat resistant plastics, contain a motor with sealed, self-lubricating ball bearings and be protected with a thermal cut-out. The fan should be double insulated, and be suitable for installation for Zones I and II. Fan to comply with all current IEE, EC and Building Regulations requirements for installation into a toilet, shower-room, bathroom or utility room.

Leaflet

Download